susie@jxgreentape.com
Industrial tape questions usually arise at three points: before a product is selected, during a sample trial, and after a problem appears in production. This center is organized around those decisions rather than around publication dates.
Use the sections below to compare tape constructions, understand technical data, investigate failures and identify the information needed before requesting a sample or quotation. If you already know the production process but not the suitable tape family, visit our Industrial Tape Applications page.
Buying Guides connect an application with the product details that need to be specified. They cover operating temperature, substrate, adhesive system, thickness, width, process conditions and purchasing information.
Use this section when you understand the production task but have not yet selected a tape construction or grade.
Material Comparisons examine the practical differences between constructions such as polyester and polyimide, mono- and bi-directional filament reinforcement, or PTFE film and PTFE-coated glass cloth.
The comparison should identify where each option normally fits, what cannot be concluded from the material name alone, and which points still require a sample trial.
Failure Analysis begins with the observed problem rather than immediately recommending a stronger or more expensive tape. Edge lifting, residue, carton failure, wrinkling and premature wear can originate from the surface, application pressure, tape width, process temperature or installation method.
Use this section to identify likely causes and prepare a controlled trial before changing product grade.
Technical Guides explain how tape constructions, temperature ratings, dielectric data, adhesion values and reinforcement affect use. They also identify where a catalogue value is useful and where it does not represent the full production condition.
Use these guides when a TDS value needs to be interpreted in the context of a process or application.
Technical documents may include a product TDS and, where available, SDS, RoHS, halogen or other compliance reports. Each document must be checked against the product number, report scope and issue date.
A report issued for one grade should not be used as evidence for every tape with the same backing material.
View Certifications and Available Reports
The Industrial Tape FAQ covers practical questions about samples, custom widths, roll lengths, minimum order quantities, lead times, storage and document requests.
Product suitability and certification questions that depend on the application should still be reviewed against the exact grade and operating conditions.
A Practical Buyer’s Guide to Filament Tape for Industrial Packaging
This guide examines reinforcement direction, adhesive behaviour, application method and packaging risk before a production order is placed.
Polyester vs Polyimide Electrical Tape for Permanent Insulation
This comparison explains where each backing normally fits and which electrical, thermal and thickness details still require grade-specific verification.
Kapton Tape for PCB Gold Finger Masking: How to Stop Edge Lifting and Solder Leakage
This failure analysis reviews surface condition, masking-edge control, solder intrusion, heat exposure and removal.
How to Evaluate Temperature Ratings for High-Temperature PTFE Tape
This guide explains why short heat exposure and continuous service should not be evaluated using the same temperature figure.
A familiar material name is not enough to identify the correct report. A RoHS or halogen report issued for one polyimide tape does not automatically cover another polyimide grade. The same rule applies to filament-reinforced electrical tape, polyester tape and PTFE tape.
When requesting documents, please provide the product number, required document type, destination market and any customer-specific approval requirement. We will confirm which current documents are available for that grade.
View Current Certifications and Reports
Request Technical Documents for a Product Grade
The Adhesives Blog contains additional articles and industry notes that do not fit one of the decision-focused categories above. For product selection, material comparison or failure investigation, use the dedicated Knowledge Center sections first.